Meggitt vibro-meter VM600 - Identifying a MPC4 Mk2 + IOC4 Mk2 Module in a Configuration

QUICK START MANUAL Document reference MAVM600MK2MPS-QS/E
VM600
Mk2
machinery protection system (MPS) Edition 2 - February 2021
1-24
MPC4
Mk2
+IOC4
Mk2
module network interface
INTRODUCTION TO THE VM600
Mk2
MACHINERY PROTECTION SYSTEM (MPS)
1.11.1 Configuring the network interface (IP address) for a MPC4
Mk2
+ IOC4
Mk2
module
VibroSight System Manager is used to configure the network interface (IP address) of a
MPC4
Mk2
+IOC
Mk2
module. See 3.3.1 Configuring the network interface for a MPC4
Mk2
module.
1.11.2 Identifying a MPC4
Mk2
+ IOC4
Mk2
module in a configuration
VibroSight Protect is used to identify a MPC4
Mk2
+IOC
Mk2
module in a VibroSight Protect
configuration. See 3.4.1 Identifying a MPC4
Mk2
module in a VibroSight Protect (MPS)
configuration.