Meggitt vibro-meter VM600 Quick Start Manual

Document reference MAVM600MK2MPS-QS/E QUICK START MANUAL
Edition 2 - February 2021 VM600
Mk2
machinery protection system (MPS)
4-1
MPC4
Mk2
module firmware
MPC4
Mk2
+ IOC4
Mk2
MACHINERY PROTECTION AND CONDITION MONITORING
4MPC4
Mk2
+IOC4
Mk2
MACHINERY PROTECTION AND
CONDITION MONITORING MODULE
This chapter provides information on the MPC4
Mk2
+IOC4
Mk2
machinery protection and
condition monitoring module.
NOTE: Refer to the VM600 MPC4
Mk2
+IOC4
Mk2
machinery protection and condition
monitoring module data sheet for detailed information on the key features and
benefits, and specifications for this module.
This includes an introduction to the different firmware that can run on the MPC4
Mk2
module
and the different operating modes of the firmware.
4.1 MPC4
Mk2
module firmware
In a VM600
Mk2
machinery protection system (MPS), it is the MPC4
Mk2
module that provides
the intelligence and controls the IOC4
Mk2
module and any associated/optional RLC16
Mk2
modules. Accordingly, only the MPC4
Mk2
module runs firmware which can be updated or
otherwise changed by the end-user/operator as required.
The MPC4
Mk2
module can run three different firmwares, as shown in Table 4-1.

Meggitt vibro-meter VM600 Specifications

General

Brand	Meggitt
Model	vibro-meter VM600
Category	Protection Device
Language	English