Meggitt vibro-meter VM600 - Rlc16

QUICK START MANUAL Document reference MAVM600MK2MPS-QS/E
VM600
Mk2
machinery protection system (MPS) Edition 2 - February 2021
2-24
RLC16
Mk2
relay module
OVERVIEW OF VM600
Mk2
MACHINERY PROTECTION SYSTEM (MPS) HARDWARE
2.4.1 RLC16
Mk2
module connector pinouts
As shown in Figure 2-4, the RLC16
Mk2
panel (rear of rack) contains three connectors,
identified as J1, J2 and J3.
Each connector consists of a male connector (socket on module) and a mating female
connector (plug on wiring):
• J1 (top) is a 16-pin connector used to connect outputs (contacts) for relays RL1 to RL6.
• J2 (middle) is a 16-pin connector used to connect outputs (contacts) for relays RL6 to
RL11.
• J3 (bottom) is a 16-pin connector used to connect outputs (contacts) for relays RL11 to
RL16.
Detailed information on the RLC16
Mk2
module’s connector pinouts (definition of terminals)
are given in Table 2-7, Table 2-8 and Table 2-9.