Document reference MAVM600MK2MPS-QS/E QUICK START MANUAL
Edition 2 - February 2021 VM600
Mk2
machinery protection system (MPS)
3-1
VibroSight System Manager
OVERVIEW OF VM600
Mk2
MACHINERY PROTECTION SYSTEM (MPS) SOFTWARE
3 OVERVIEW OF VM600
Mk2
MACHINERY PROTECTION
SYSTEM (MPS) SOFTWARE
This chapter provides a brief overview of the software used with the VM600
Mk2
machinery
protection system (MPS) hardware, that is, the VibroSight
®
software.
NOTE: The VibroSight
®
machinery monitoring system software, from Meggitt’s
vibro-meter
®
product line, is a highly-integrated software suite that supports the
effective monitoring of all rotating machinery.
This includes an introduction to the relevant VibroSight
®
software modules and the basic
tasks required to configure and manage a VM600
Mk2
MPS.
In general:
• VibroSight System Manager is the software used to manage VM600
Mk2
MPS
hardware/systems in general.
• VibroSight Protect is the software used to configure and work with VM600
Mk2
MPS
hardware for specific applications/solutions.
For information on the VM600
Mk2
machinery protection system (MPS) hardware, see
2 Overview of VM600
Mk2
machinery protection system (MPS) hardware.
NOTE: For further information on the VibroSight
®
software in general, refer to the
VibroSight software release notes and VibroSight help.
3.1 VibroSight System Manager
VibroSight System Manager is the VibroSight client application software module that
provides the tools to manage VibroSight-compatible machinery monitoring system hardware,
such as VM600
Mk2
machinery protection system (MPS) hardware.
For example, VibroSight System Manager is used to manage the VibroSight
software
(activate and/or upgrade software licenses), configure VM600 module/card IP addresses and
upgrade VM600 module/card firmware.
3.2 VibroSight Protect
VibroSight Protect is the VibroSight client application software module used for the
configuration and operation of VM600
Mk2
machinery protection system (MPS) hardware, that
is, the second generation of VM600 rack-based machinery protection system (MPS)
hardware.
More specifically, it is used to configure:
•MPC4
Mk2
+IOC4
Mk2
machinery protection and condition monitoring modules
• RLC16
Mk2
relay modules.
To Next Page
Loading...
Need help?
General