119
Chapter 6 Parameter Description
The parameter format is as follows:
6.1 System management parameters (Group P00)
0: Quick menu mode
Only the parameters related to the quick running of the drive will be displayed. To start the drive quickly,
change the parameters under this menu mode.
1: Full menu mode
Display all the parameters (excluding the hidden function codes associated to the function code).
2: Verification menu mode
Only the parameters that are different from the leave-factory values will be displayed (except for P00.03).
The password setting function is used to prohibit the unauthorized person from viewing and modifying the
function parameters.
To set the password:
If you need this function, input a four-digit number as the user password and then press ENTER/DATA to
confirm. After the confirmation, you need to re-enter this function code to input the same value and press
ENTER/DATA to confirm within 10s. When “P.SEt” is displayed, the password is successfully set. If there
is no other key operation within 5 minutes or re-power after power down, the password will become
effective automatically.
To change the password:
Press MENU/ESC to enter the password verification status and input the correct original four-digit
password to enter the parameter editing status. Select P00.01 (at this moment, P00.01 displays 00000).
Setting the new password is the same as above.
To clear the password:
Press MENU/ESC to enter the password verification status and input the correct original four-digit
password to enter the parameter editing status. Select P00.01 (at this moment, P00.01 displays 00000).
The process of clearing password is the same as that of setting new password, however, you need to
input 0000 twice. When the password is successfully cleared, “P.Clr” is displayed.
Note
Please keep the user password properly. This is no user password as default.
LCD display language selection 0~1 (0)
P00.02
User passwor
0~65535 (0)P00.01
Menu mode selection 0~2 (0)P00.00
Menu name
Value range (default value)
Menu No.
To Next Page
Loading...
Need help?
General
