Megmeet MV600 Series - Fieldbus Option Parameters (Group P40)

217
This function code indicates the motor temperature measured in actual situation.
P16.09~P16.11 are used for indicating the accumulated power-up hours, running hours and running
hours of the fan of the drive from leaving the factory to now.
6.18 Fieldbus option parameters (Group P40)
The field bus option parameter group is used for indicating and setting parameters for the bus options.
This group of function codes is displayed only when the bus option works normally.
000: No communication option
001: Profibus-DP
Others: Reserved
P40.01 and p40.02 are used for representing the hardware version and software version of the option
respectively.
Option reset action selection
0: Do not reset or reset successfully
1: Enable option reset
Profibus-DP bus PPO type selection
1~5: PPO1~PPO5.
This function code is used for indicating and setting the communication baud rate.
When the option is a Profibus-DP card (P40.00 = 001), this function code is used for indicating the current
communication baud rate and the corresponding baud rates are shown as follows:
0: 9.6 kbps 1: 19.2 kbps 2: 45.45 kbps
3: 93.75 kbps 4: 187.5 kbps 5: 500 kbps
6: 1.5 Mbps 7: 3 Mbps 8: 6 Mbps
9: 12 Mbps
Other options: Reserved
Option fault status display
O
p
tion fault dis
p
la
y
0~1
(
0
)
P40.25
Communication baud rate dis
p
la
y
or selection 0~99
(
0
)
P40.24
Profibus-DP PPO t
yp
e selection 1~5
(
1
)
P40.23
O
p
tion reset selection 0~1
(
0
)
P40.22
Reserved 0P40.03~P40.21
O
p
tion software version 0.00~99.99
(
1.00
)
P40.02
O
p
tion hardware version 0.00~99.99
(
1.00
)
P40.01
O
p
tion t
yp
e 000~FFF
(
000
)
P40.00
Accumulated runnin
g
hours of fan 0~65535
(
0
)
P16.11
Accumulated runnin
g
time 0~65535
(
0
)
P16.10
Accumulated
p
owe
r
-on hours 0~65535
(
0
)
P16.09