Megmeet MV600 Series - Protection and Fault Parameters (Group P97)

218
0: Option is normal
1: Option wire-break or other faults
Please refer to the Option Manual for details.
Please refer to the Option Manual for details.
6.19 Protection and fault parameters (Group P97)
UintTens
Thousands
Action upon contactor abnormality :
0 : Activate protection and coast to stop
1 : Alarm and keep running
Action upon communication fault :
0 : Activate protection and coast to stop
1 : Alarm and keep running
2 : Alarm and stop in the stop mode (only in
serial port control mode)
3 : Alarm and stop in the stop mode (in all
control modes)
Hundreds
Action upon EEPROM abnormality :
0 : Activate protection and coast to stop
1 : Alarm and keep running
Action upon 24V/±10V short circuit :
0 : Activate protection and coast to stop
1 : Alarm and keep running
Fig. 6-79 Fault protection and alarm property setting 1
Fault protection and alarm property setting 2 0~2223H (0000)P97.01
Fault
p
rotection and alarm
p
ro
p
ert
y
settin
g
1 0~1113H
(
0000
)
P97.00
In
p
ut data ma
pp
in
g
0~9999
(
0
)
P40.40~P40.49
Out
p
ut data ma
pp
in
g
0~9999
(
0
)
P40.30~P40.39
Rese
r
ved 0P40.26~P40.29