Megmeet MV600 Series - Page 97

97
to the
minimum
reference of
curve 1
to minimum
reference 1
P10.22
Types of
analog
output
Types of
analog
output
Unit place of LED: AO1 selection
0: 0~10V(0~20mA)
1: 2~10V(4~20mA)
The current and voltage depend
on the hardware
Tens place of LED: AO2 selection
0: 0~10V(0~20mA)
1: 2~10V(4~20mA)
The current and voltage depend
on the hardware
1 00 √ √ ○
P10.23
Analog
output
terminal
AO1
functions
AO1
functions
0: Output frequency (0~ maximum
frequency)
1: Set frequency (0~ maximum
frequency)
2: Set frequency (after
acceleration/deceleration) (0~
maximum frequency)
3: Motor rotating speed (0~
maximum rotating speed)
4: Output current (0~2*Ie)
5: Output current (0~2*Iem)
6: Output torque (0~3 * Tem)
7: Output torque current
(0~3*Item)
8: Output voltage (0~1.2*Ve)
9: Bus voltage (0~800V)
10: AI1 after adjustment
11: AI2 after adjustment
12: AI3 after adjustment
13: Output power (0~2*Pe)
14: Percentage of host device
(0~4095)
15: Torque limit value 1
(+10V/+300%)
16: Torque limit value 2
(+10V/+300%)
17: Torque offset (+10V/+300%)
18: Torque command
(+10V/+300%)
19: Flux command (+10V/+100%)
20: Reserved (position deviation
(+10V/2048 command pulse))
21: Output torque
(-300.0~+300.0%)
1 00 √ √ ○