ENGINE MECHANICAL SERVICE MANUAL NUMBER 22
Page 3A-120 90-860074--1 FEBRUARY 2002
9. To assist in removing the bearing carrier, temporarily reinstall the flywheel housing using
only the nuts on the carrier.
10. Tap evenly around the housing as shown. The carrier and thrust plate will be pulled from
the cylinder block.
70303
a
b
c
a-Nuts On Carrier (6)
b-Flywheel Housing
c-Plastic Hammer
11. Remove nuts temporarily holding the flywheel housing to the rear bearing carrier, and
proceed to next appropriate section.
To Next Page
Loading...
