MAINTENANCE
SERVICE MANUAL NUMBER 22
90-860074--1 FEBRUARY 2002 Page 1B-55
Cleaning
1. Wash air cleaner element in warm water and detergent until clean.
IMPORTANT: No treatment (such as partial oil saturation) is required or
recommended on air cleaner foam element prior to use. Use element clean and dry
for proper filtration.
2. Allow air cleaner element to completely dry before use.
Installation
1. Install air cleaner element around air intake screen.
2. Connect crankcase vent hose to end of intake screen housing. Tighten hose clamp
securely.
IMPORTANT: To prevent unfiltered air from entering the engine be certain that all of
the air intake screen is covered by the foam element when installed.
3. Inspect installation to ensure engine draws in filtered air only.
To Next Page
Loading...
Need help?
General