MAINTENANCE
SERVICE MANUAL NUMBER 22
90-860074--1 FEBRUARY 2002 Page 1B-67
Draining
IMPORTANT: Drain only the seawater section of the cooling system. Closed cooling
section must be kept filled year-round with specified coolant.
1. Ensure that the engine is as level as possible to promote complete draining of the
cooling system.
CAUTION
If boat is to remain in the water, seacock, if equipped, must be closed until engine
is to be restarted to prevent water from flowing back into seawater cooling system.
If boat is not fitted with a seacock, water inlet hose must be disconnected and
plugged to prevent water from flowing into cooling system and/or boat. As a
precautionary measure, attach a tag to the ignition switch or steering wheel with the
warning that the valve must be opened or the water inlet hose reconnected prior to
starting the engine.
2. Close seacock, or disconnect and plug seawater inlet hose, if boat is to remain in the
water.
IMPORTANT: Drain only the seawater section of the cooling system. Closed cooling
section must be kept filled year-round with specified coolant.
3. Do NOT open either of these two drain valves in the closed cooled section.
75297
b
71364
a
76391
Typical
a-Exhaust Manifold Drain Valve
b-Engine Block Drain Valve
To Next Page
Loading...
Need help?
General