INJECTION PUMP SERVICE MANUAL NUMBER 22
Page 5D-22 90-860074--1 FEBRUARY 2002
18. Ensure injection pump key is properly positioned.
IMPORTANT: Do NOT force gear on shaft.
19. Install gear on injection pump shaft, using whichever key slot on gear that allows gear
to be installed the easiest.
20. Using a new lockwasher, install gear on shaft with hex nut. Torque to 88 Nm (64 lb-ft).
22217
70424
a
b
c
a-Gear
b-New Lockwasher
c-Hex Nut
21. Timing of the injection pump MUST BE accomplished. Refer to Fuel Injection Pump
Timing in this section for instructions.
To Next Page
Loading...
Need help?
General