SEAWATER COOLING SYSTEM SERVICE MANUAL NUMBER 22
Page 6A-26 90-860074--1 FEBRUARY 2002
3. Install pump on timing gear cover studs. Tighten hex nuts with washers securely.
70423
23161
a
b
Typical Pump Installation
a-Studs
b-Hex Nuts With Washers
4. Install seawater inlet and outlet hoses. Tighten hose clamps securely.
70636
c
c
b
a
Typical Pump and Hoses
a-Inlet Hose
b-Outlet Hose
c-Hose Clamps
5. Open seacock, if equipped, or remove plug from seawater inlet hose and reconnect
hose. Tighten hose clamps securely.
6. Start engine.
7. Check for leaks.
To Next Page
Loading...
Need help?
General