Section 9 - Pre-Delivery Information
Page 140 90-879172181 eng FEBRUARY 2011
Pre‑Delivery Information
IMPORTANT: This section of the Operation, Maintenance, and Warranty Manual guides our boat dealers and boat company
service personnel in the proper initial (pre‑delivery) service of the Cummins MerCruiser Diesel Zeus products. The Dealer
Pre‑Delivery Checklist must be completed prior to delivery of the product to the customer and is not a substitute for the maintenance
schedules listed in this manual. If you have not been trained in the recommended service procedures for this product, contact an
authorized Cummins MerCruiser Distributor / Dealer technician to have the work performed. Improper pre‑delivery checks,
inspection, or servicing of this Cummins MerCruiser Diesel product could result in damage to the product or personal injury to
those servicing and operating the product.
Dealer Pre‑Delivery Checklist for Zeus Products (Before Delivery to the
Customer)
Publication Name Publication Part Number Manual Code
QSB Owners Manual 4024182 QSB OM
QSC Owners Manual 4021481 QSC OM
QSM Owners Manual 4021940 QSM OM
Zeus Operation, Maintenance, and Warranty Manual 90‑879172181 ZOM
VesselView Operation Manual 90‑8M0050668 VVM
Captain's Briefing Information Brochure 3381956 –
Warranty Registration Card 90‑842801002 –
Skyhook (If Equipped)
Publication Name Publication Part Number Manual Code
Skyhook Operational DVD 90‑899883257 –
Skyhook Quick Reference Card 90‑899883258 –
Skyhook Warning Label Placement instructions 90‑899883259 –
Skyhook Helm Label 8M0034159 –
SKyhook Passenger Label 8M0034160 –
Before Starting—Key Off
Dealer Check Checklist Item Manual Code or Task
☐ Identification Record table listed on front page is filled out. ZOM
☐ Copy of all required support publications present Visual Inspection
☐ Drive skegs and propellers are installed Visual Inspection
☐ Engine mount and isolator mounting capscrews are tight Visual Inspection
☐ Driveshaft and shields mount cap screws are tight Visual Inspection
☐ All fuel connections are tight Visual Inspection
☐ Raw water (seawater) system hose clamps are tight Visual Inspection
☐ Exhaust system hose clamps are tight Visual Inspection
☐ All electrical connections secure Visual Inspection
☐ Coolant recovery bottle and expansion tank level—check/fill Engine OM Section V
☐ Engine oil level—check/fill Engine OM Section V
☐ Steering actuator and trim fluid level—check/fill ZOM Section 5
☐ Transmission fluid level—check/fill ZOM Section 5
☐ Drive gear lube fluid level—check/fill ZOM Section 5
☐ Seacocks open (See Starting and Stopping the Engines.) ZOM Section 3
To Next Page
Loading...
Need help?
General
