Section 3 - On the Water
Page 56 90-879172181 eng FEBRUARY 2011
4. Press the "TRACK WAYPOINT" button on the Precision Pilot keypad. The "TRACK WAYPOINT" button light turns on and a
single horn beep sounds, indicating Track Waypoint engaged. Pilot tracks to the first waypoint on the chart plotter course.
Two horn beeps sound if Track Waypoint does not engage.
27701
"TRACK WAYPOINT" button
5. The VesselView "TRACK WAYPOINT" screen displays on VesselView for one second after pressing the "TRACK
WAYPOINT" button. The display shows the digital heading that the boat is traveling, the angles of the drives, and engine
speed in RPM. See Mode Display in VesselView.
NOTE: The displayed heading is based on magnetic North.
Track Waypoint screen—dual engine application screen shown
NOTE: The Precision Pilot "TURN" buttons will not initiate turns when Track Waypoint mode is engaged. Turn features are
only available in Auto Heading mode.
Disengaging Track Waypoint Mode
Disengage the Track Waypoint mode by one of the following methods:
• Press the "TRACK WAYPOINT" button on the Precision Pilot keypad. The "TRACK WAYPOINT" button light goes off and
Pilot goes to Standby. The "STANDBY" light turns on
• Turn the steering wheel hard enough to overcome the force feedback and Pilot goes to Standby.
• Move both ERC levers back to neutral and Pilot goes to Standby.
• Press the "AUTO HEADING" button and Pilot goes to Auto Heading mode.
• Turn off the chart plotter and Pilot goes to Standby.
To Next Page
Loading...
Need help?
General
