AC1200 Wireless Dual Band Gigabit Router
11 a/n/ac mixed - Select if you are using a mix of 802.11a, 802.11n and 802.11ac
wireless clients.
11 a/n mixed - Select if you are using both 802.11a and 802.11n wireless clients.
• Channel Width - Select the channel width from the drop-down list
. The default setting is
Auto, which can adjust the channel width for your clients automatically.
• Transmit Power - Select either High, Middle, or Low to specify the data transmit power.
The default and recommended setting is High.
• Enable SSID Broadcast - If you select the Enable SSID Broadcast checkbox, the wireless
router will broadcast its name (SSID) on the air.
• AP Isolation - Select this checkbox to enable the AP Isolation feature that allows you to
confine and restrict all wireless devices on your network from interacting with each other,
but still able to access the Internet. AP isolation is disabled by default.
5.3.2 Guest Network
Go to 5GHz Wireless→Guest Network, you can configure the settings for the wireless guest
network on this page.
• Guest Network - Click to enable or disable the Guest Network function here.
• SSID/Password - Set the network name and password for Guest Network. Password may
contain 8-63 characters. It is recommended you use a combination of numbers, letters
and symbols.
• Access my local network - If Yes is selected, the wireless devices on the guest network
are able to access your local network. The default value is No.
• Upstream Bandwidth - The upload speed through the WAN port for Guest Network.
- 35 -
To Next Page
Loading...
Need help?
General
