Mercusys AC1200 - Advanced Routing

AC12G
AC1200 Wireless Dual Band Gigabit Router
• Refresh - Click to update the current UPnP settings list.
5.5.4 Advanced Routing
Go to Advanced Users→Advanced Routing, and then you can configure the static routing and
view system routing list. Advanced routing is used to predetermine a fixed route for the
network information packets to reach a specific host or network.
●
Static Routing
• Destination Address - The address of the network or host that you want to assign to a
static route.
• Subnet Mask - The Subnet Mask determines which portion of an IP Address is the network
portion, and which portion is the host portion.
• Next Hop - The IP Address of the gateway device that allows for contact between the
router and the network or host.
• Edit - Here you can edit an existing entry.
• Add - Click to add a new rule entry.
• Delete All - Click to delete all the entries in the table.
• Delete Selected - Click to delete selected entries in the table.
To add a static routing entry:
1. Click Add.
2. Enter the parameters in the corresponding fields.
3. Click Save to make the settings effective.
- 44 -