5 Assembly and Installation
46
Meritor Maintenance Manual MM-15103 (Issued 07-17)
Figure 5.71
14. Tighten the nut onto the drive pinion to the correct torque
value. Refer to Table H in Section 7.
Install the Differential Carrier into the Axle
Housing
Solvent cleaners can be flammable, poisonous and cause
burns. Examples of solvent cleaners are carbon tetrachloride,
and emulsion-type and petroleum-base cleaners. Read the
manufacturer’s instructions before using a solvent cleaner,
then carefully follow the instructions. Also follow the
procedures below.
앫 Wear safe eye protection.
앫 Wear clothing that protects your skin.
앫 Work in a well-ventilated area.
앫 Do not use gasoline or solvents that contain gasoline.
Gasoline can explode.
앫 You must use hot solution tanks or alkaline solutions
correctly. Read the manufacturer’s instructions before
using hot solution tanks and alkaline solutions. Then
carefully follow the instructions.
When you apply some silicone gasket materials, a small
amount of acid vapor may be present. To prevent serious
personal injury, ensure that the work area is well-ventilated.
Read the manufacturer’s instructions before using a silicone
gasket material, then carefully follow the instructions and use
appropriate safety equipment. If a silicone gasket material
gets into your eyes, follow the manufacturer’s emergency
procedures. Have your eyes checked by a physician as soon as
possible.
1. Clean the axle housing and the carrier mounting surfaces
according to the detailed instructions in Section 4.
2. Inspect the axle housing for damage. Repair or replace the axle
housing. Refer to Section 4.
Apply silicone gasket material in a continuous 0.25-inch
(6 mm) bead. If you use more than this amount, gasket
material can break off and plug lubrication passages. Damage
to components can result.
3. Apply a continuous 0.25-inch (6 mm) bead of Loctite
Ultra
Grey sealant, Meritor specification 2297-H-7054, to the
mounting surface of the housing where the carrier fastens.
Refer to Section 4. Figure 5.72.
Figure 5.72
4. Install the carrier into the axle housing. Use a hydraulic roller
jack or a lifting tool.
Do not install the carriers using a hammer or mallet. A hammer
or mallet will damage the mounting flange of the carrier and
cause oil leaks.
5. Install tapered dowels, if equipped, at the locations shown in
Figure 5.73.
Figure 5.71
Figure 5.72
0.25" (6 MM)
DIAMETER SILICONE
GASKET BEAD
4004435a
To Next Page
Loading...
