Microengine XP-GT Series

To Next Page

To Previous Page



32



MicroEn

ine



XP-GT/GTR Programming Manual

v4.00

Event

Code

Event Event

Code

Event Event

Code

Event Event

Code

Event

0 Valid Entry Access G Door Forced Open W Output Isolated m Tr M

ntiPassBack Violation H Card Locked Out X Input On n Tr N

2 Unknown Card Number I Reset Lock Out Y Input Off o Door Supervisor Off

3 Wrong Facility Code J Wrong Time Zone Z Change PIN p Fire Alarm On

4 Reader Reset K Duress Alarm a Valid PIN Access q Fire Alarm Off

5 Reader Up L Door Interlocked b Card Disabled r Tamper On

6 Reader Down M

larm On c Card Enabled s Main Fail

7 Controller Reset N

larm Off d Pulse Door Open t Mains Normal

8 Enter Prog. Mode O Door Security e Door Open u Power Low

9 Exit Prog. Mode P

larm Delay Arm St f Invalid PIN Access v Power Normal

A Memory Cleared Q

larm Armed g Inactive Card w Door Inhibit On

B Reset AntiPassBack R

larm Trigger h Card Expired x Door Inhibit Off

C Door Supervisor On S

larm Disarm i Valid Exit Access y Door Inhibited

D Wrong PIN/Password T

larm Isolated j ColdStart z Not Supervisor Door

E Door Left Open U Output On k Door Security On

F Door Closed V Output Off l Door Security Off

Table 1: The 62 events that can be programmed to trigger the output.

Microengine XP-GT Series - Page 32