Microengine XP-GT Series - Sounder Setting



30

MicroEn
g
ine
®

XP-GT/GTR Programming Manual
v4.00
8. The screen below will be shown. Enter the Gateway IP for the network
and press
√ to proceed to the next screen.
Network Settings
Enter Gateway
(192).[168].[001].[001]
√ - OK X - Cancel
9. The screen below will be shown to prompt users to save all changes.
Press
√ to save all changes.
10. Please note that the controller will then restart automatically to allow the
changes to take effect immediately.
Network Setting
Save Changes?
√ - OK X - Cancel
1.8 Sounder Setting
This menu lets users program the sounder to activate at a specific time of the day. It
can be programmed to activate up to 3 times a day and different time configurations
can be implemented for different days of the week including holidays.
To program the sounder setting, please follow steps below:
1. Enter Configuration Menu.
2. Press 1 for System Menu.
3. Press 8 for Sounder Setting. The screen below will be shown. Press
↑ or
↓ to select the day and press √ to proceed to the next screen.
Sounder Setting
Select the Day of Week
(Sun > Hol)
[Sun]
√ - OK X - Cancel
4. The screen below will be shown. Press ↑ or ↓ to select the Time 00, 01,
and 02, and then enter the timestamp that users want to activate the alarm
output. Press
√ to proceed to the next screen.