Microengine XP-GT Series - Door Parameter



15

MicroEn
g
ine
®

XP-GT/GTR Programming Manual
v4.00
NOTE
:- If controller has established communication with the software, the date
& time will automatically be synchronized with the PC’s date & time.
1.2 Door Parameter
This menu allows users to edit general door operation settings for the controller.
To program the door parameter setting, please follow steps below:
1. Enter Configuration Menu.
2. Press 1 for System Menu.
3. Press 2 for Door Parameter.
4. Press
↑ or ↓ to navigate the pointer to the desired parameter.
5. Press
√ to edit the settings, followed by the desired setting values and √
again to save changes.
6. The screen below is shown, with the list of parameters available to program.
Door Parameter
▸Lock Release Time
10
Door Open Time 15
Lock Release TZ 00
Exit Button TZ 01
√
- OK X - Cancel
7. Press
X if users wish to return to System Menu.
8. Screen as below will be shown. Press
√ to save changes.
Door Parameter
Save Changes?
√ - OK X – Cancel
Set Date & Time
Save Changes?
√ - OK
X - Cancel