37
MicroEn
ine
XP-GT/GTR Programming Manual
v4.00
Delete User
Enter User No.
ID: [123456]
User Deleted
√ - OK X - Cancel
2.4 Edit User Settings
This menu allows users to edit settings to users already added to the database.
To edit user settings, please follow steps below:
1. Enter Configuration Menu.
2. Press 2 for Database Menu.
3. Press 4 for Edit User Settings. Screen as below will be shown. Enter the
user number and press
√ to proceed to the next screen.
Edit User Setting
Enter User No.
ID: [------]
√ - OK X - Cancel
4. Screen as below will be shown. Enter the pre-set Time Zone to grant door
access for this user. Press
√ to proceed to the next screen.
Edit User Setting
Edit TimeZone No.
TimeZone: [01]
√ - OK X - Cancel
5. Screen as below will then be shown. Select the verification mode for this user
by specifying the number corresponding to the verification mode.
i. [0] is by door (The verification mode for the user will be according to the
current verification mode of the door entered/exited)
ii. [1] by Token only
iii. [2] is by Token and Pin
iv. [3] is by Token and Fingerprint
NOTE:- By default, all newly installed
users will have Time Zone of
[01] to allow full access at all
times.
To Next Page
Loading...