Microengine XP-GT Series - Page 50



50

MicroEn
g
ine
®

XP-GT/GTR Programming Manual
v4.00
4. Press 2 for Arm Delay. Screen as below will be shown. Press 1 or 2 to
select the sensor. Press
# to confirm and proceed to set the Arm Delay time.
Enter duration between “0000” and “3599” in seconds and press
√ to save
changes.
Arm Delay
Enter Input No.[?]
(Min=01, Max=02)
Arm Delay : [0000]s
√ - OK X - Cancel
5.1.3 Trigger Delay
This menu lets users program the trigger delay time once the armed sensor detected
changes in the environment.
To set the trigger delay for the sensor, please follow steps below:
1. Enter Configuration Menu.
2. Press 5 for Alarm Menu.
3. Press 1 for Input Setting.
4. Press 3 for Trigger Delay. Screen as below will be shown. Press 1 or 2 to
select the sensor. Press
# to confirm and proceed to set the trigger delay
time. Enter duration between “0000” and “3599” in seconds and press
√ to
save changes.
Trigger Delay
Enter Input No.[?]
(Min=01, Max=02)
Trigger Delay: [0000]s
√ - OK X - Cancel
5.1.4 Sensor Arm Tz
This menu lets users program the time zone to arm sensors. This will determine the
day of the week and the time of the day where the sensor will be armed.
To set the sensor arm Time Zone, please follow steps below:
1. Enter Configuration Menu.
2. Press 5 for Alarm Menu.
3. Press 1 for Input Setting.
4. Press 4 for Sensor Arm TZ. Screen as below will be shown. Press 1 or 2 to
select the sensor. Press
# to confirm and proceed to set the time zone to arm
the sensor. Press
√ to save changes.