Reference: The Information Window 93
Cursor Locator
The
Cursor Locator Cursor Locator
Cursor Locator Cursor Locator
Cursor Locator shows where the cursor is on the coordinates along the x
(horizontal) and y (vertical) axis, based on the unit of measurement selected for
the rulers. This feature is useful for operations that require very precise
measurements and alignment.
Input value
This data
indicate the input density values of the scanned raw image data. This
information is useful for you to locate Dmin/Dmax points.
Output value
This data
indicate the output values of the selected image type. The image type
is selected from Settings window. The value at the left side is the image data
before processing by White/Black points, Tone Curve, Brightness/Contrast, Color
Corrections, and Filters. At the right side is the image data after the processing
(White/Black points, Tone Curve, Color Corrections, and Filters) .
Indications of output value range depend on output image types. See the table
below.
Image Type Pixel Range
8-bit color 0 - 255
10-bit color 0 - 1023
12-bit color 0 - 4095
CMYK 0 - 100%
Gray Scale 0 - 100%
To Next Page
Loading...
Need help?
General
