EasyManua.ls Logo

Midas DL431 - Chapter 8 Application Notes; Using the 30 Hz Filter

Midas DL431
78 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
55
DL431 Mic Splitter
Operator Manual
Chapter 8: Application Notes
Using the 30Hz filter
The DL431 Mic Splitter’s 30Hz filter is an analogue high pass filter (HPF). It is a very
low frequency signal filter with a 30Hz corner frequency and 12dB per octave
Butterworth roll off. This filter can be switched into circuit following the mic amp to
make better use of the A/D conversion headroom by removing the very low frequency
audio content.
High pass filters are used to remove unwanted subsonic frequencies, which are
traditionally about 30Hz. A typical use for this filter is to reduce rumble.

Table of Contents

Related product manuals