Technical Information
97
Displayed Message Information
STANDBY…
The appliance is in the energy saving
• Press ENTER
WATER SYSTEM FAULT
The level switch has been actuated by
water being present in the base of
the appliance
• Clear unit of water from lower pan and
locate / repair source of leak.
• Check level switch for proper
operation
FILL WATER TANK
The water tank level switch is not
actuated – water tank float is below the
switch level
• Refill the water tank
• Check that float and switch operate
EMPTY WATERTANK
• Check that flowmeter is plugged into
the correct position of the electronic
WARMING UP…
Appliance is warming up, as warming up
the “. . .” in the display disappear
Table 6-4: Displayed Messages (continued from Table 6-3)
To Next Page
Loading...
