Technical Information
25
4.11 Grinder Assembly
Refer to figure 4-12.
The grinding grade depends on
the gap between the Grinding
Cone and the Grinding Ring.
The gap is set via an adjustment
Lever fitted to the adjustment
ring.
The smaller the gap, the finer the
coffee grind.
Warning!
To avoid damage to the grinder,
the grinder should only be
adjusted in small steps.
Figure 4-12: Grinder Assembly
1. Seal
2. Bracket
3. Lock Ring
4. Ring
5. Ball (3) (2mm)
6. Spring
7. Cover
8. Motor Bracket
9. Vibration Dampener (3)
10. Reinforcement Ring
11. Felt Ring
12. Cover
13. Worm Gear
14. Cone
15. Mounting
16. Ball (3) (5mm)
17. Carrier (3)
18. Motor
To Next Page
Loading...
