Miele H350 - 5.13 Cleanglass Door Panel Removal

Novotronic Models
Technical Information
40
5.13 Cleanglass Door Panel -Removal
1. Perform door removal procedure
2. Remove the screws
Figure 5-13: Removing the Holding Strip
3. Remove the holding strip
Figure 5-14: Removing the CleanGlass Door Panel
4. Lift the CleanGlass door panel slightly and slide it out of the top
holding strip
Warning
When fitting the CleanGlass door panel, the loose sealing strips on the
door inner panel must not slide out of position. The correct positioning of
the sealing strips ensures no steam gets between the panes of glass
during operation of the oven