Novotronic Models
Technical Information
48
5.25 Convection Heating Fan - Removal
1. Perform door removal procedure
2. Perform oven removal
3. Perform rear panel removal
4. Perform shelf runner removal
5. Perform enamel rear panel removal
Note:
The impeller nut has left handed threads
6. Remove the impeller nut
7. Remove the impeller and its washer
8. Disconnect the fans electrical connections at the rear of the unit
9. Remove the fans retaining screws
10. Remove the fan
5.26 Fumes Extractor - Removal
1. Perform door removal procedure
2. Perform oven removal
3. Perform front cover removal
4. Perform rear cover removal
5. Remove the air guide duct mounting screws
6. Remove the air guide duct
7. Remove the outlet connection
8. Remove the fumes extractor mounting screws from the cavity
9. Remove the fumes extractor upwards
5.27 Cooling Fan - Removal
1. Perform oven removal
2. Perform front cover removal
3. Perform rear cover removal
4. Remove the vent duct retaining screw from the catalyser cover or
supporting bracket for models without catalyser
5. Remove the cooling fans mounting screws
6. Disconnect the cooling fans electrical connections
7. Lift the vent duct slightly and remove fan
To Next Page
Loading...