Miller Auto Continuum 500 - Installation; Selecting a Location

OM-277115 Page 16
SECTION 5 − INSTALLATION
! Special installation may be required
where gasoline or volatile liquids are
present − see NEC Article 511 or CEC
Section 20.
! Do not stack units. Beware of tipping.
1 Lifting Eye
2 Lifting Forks
Use lifting eye or lifting forks to move unit.
If using lifting forks, extend forks beyond
opposite side of unit.
3 Hand Cart
Use cart or similar device to move unit.
4 Line Disconnect Device
Locate unit near correct input power supply.
5-1. Selecting A Location
4
18 in.
(460 mm)
18 in.
(460 mm)
OR
1
2
Movement
Location And Airflow
Loc_continuum 2018-08
3
OR
! Do not move or operate
unit where it could tip.
Visit www.youtube.com/
MillerWelders for
informational videos.
Notes