Miller Axcess E 300 - Section 7 − License Agreement; Section 8 − General Installation; Serial Number and Rating Label Location; Selecting a Location

General
OM-244 814 Page 27
SECTION 7 − LICENSE AGREEMENT
You have acquired a device (Axcess E) which includes software licensed by Miller Electric Mfg. Co. from one or more software licensors (EUROTECH,
Inc. software suppliers). Such software products, as well as associated media, printed materials, and “online” or electronic documentation for such
software are protected by international intellectual property laws and treaties. The software is licensed, not sold. All rights reserved.
SECTION 8 − GENERAL INSTALLATION
8-1. Serial Number And Rating Label Location
The serial number and rating information for this product is located on the front. Use rating label to determine input power requirements and/or rated
output. For future reference, write serial number in space provided on back cover of this manual.
8-2. Selecting A Location
loc_2 3/96 - 245 733-A
! Do not stack units. Beware of
tipping.
1 Lifting Forks
Use lifting forks to move unit.
Extend forks beyond opposite side
of unit.
2 Hand Cart
Use cart or similar device to move
unit.
3 Line Disconnect Device
Locate unit near correct input
power supply.
Movement
2
Location
18 in.
(460 mm)
3
! Do not move or operate
unit where it could tip.
Tipping
1
OR
! Special installation may be required where gasoline or volatile
liquids are present − see NEC Article 511 or CEC Section 20.
18 in.
(460 mm)