Miller Axcess E 300 - Section 11 − Maintenance; Routine Maintenance; Blowing out Inside of Unit

Maintenance
OM-244 814 Page 51
SECTION 11 − MAINTENANCE
11-1. Routine Maintenance
! Disconnect power
before maintaining.
. Maintain more often
during severe conditions.
n = Check Z = Change ~ = Clean l = Replace
* To be done by Factory Authorized Service Agent
Reference
Every
3
Months
l Unreadable Labels ~ Weld Terminals l Damaged Gas Hose nl Weld Cables
nl Cords nl Gun Cables
Every
6
Months
OR
~ Drive Rolls ~ Inside Unit
11-2. Blowing Out Inside Of Unit
! Do not remove case when
blowing out inside of unit.
To blow out unit, direct airflow
through front and back louvers as
shown.
245 733-A