Milli-Q Millipore - Installing the Quantum Cartridge

Milli-Q® Reference System 27
Installing the Quantum® Cartridge
Procedure
Follow the steps below to install a new Quantum® Cartridge.
Step
Action
Diagram
1
Open the right door of the
System Cabinet.
Remove the 2 protective caps
located on the ports inside.
2
Remove the covers on the
2 ports of the Quantum®
Cartridge.
Wet the O-rings with water.
3
Install the Quantum® Cartridge
until it is fully seated.
Close the right door.
4
One minute later, the Main LCD
shows that a new Quantum®
Cartridge is installed.
5
Press .