Milli-Q Millipore - System Maintenance Procedures Continued; Flowrate Calibration Conditions

74 Milli-Q® Reference System
Calibrating the Flowrate
When
The flowrate should be calibrated when a:
• new consumble is installed such as a:
− POD Pak or
− Q-Gard® Pack and
− Quantum® Cartridge.
• sensor or major component is changed.
• feedwater parameter has changed such as the:
− pressure
 setting of pressure regulator,
 larger or smaller Reservoir or
 Inlet Strainer cleaned
−
temperature changed (> 3°C).
Procedure
Follow the procedure shown in the Installation Chapter.