Milli-Q Millipore - Ready Mode Operation; Ready Mode Display Information

44 Milli-Q® Reference System
Ready Mode
General information
Purpose
In READY Mode, water can be dispensed from the POD Unit. The System should be left
in READY Mode most of the time.
Display
STANDBY Mode
from READY
Mode
Display
Action
Result
Press .
READY Mode –
water quality
values
The READY Mode screen display is explained below.
READY Mode screen
Explanation
In this example, the water being dispensed has:
• a resistivity of 18.2 MΩ.cm temperature
compensated (TC) to 25°C,
• a temperature of 24.9°C, and
• the TOC is not measured.
In this example, the System is powered on but is
not dispensing or recirculating water. As a result,
there are no water quality measurements to
display.
NOTE:
A Milli-Q® Reference System can be upgraded to
have TOC measurements. Contact Millipore SAS
for more information.