SELECT
This key is freely programmable. Up to six fre-
quently used functions or subfunctions can be
assigned to this key.
To assign a function to the key, simply select
the required function in the catalog of functions
and parameters and press the SELECT key. The
message “SELECT x” appears, whereby the “x”
stands for one of the key’s six memory locations
.
It is not possible to save different
parameter values (e.g. the factor
“0.3”) or settings (e.g. the measuring
unit “MM”) to the SELECT key.
If SELECT is pressed in measuring mode, the
function assigned to memory location 1 is dis-
played. Continually pressing SELECT scrolls
through the other functions saved to the key.
Press MENU to make parameter settings or en-
ter numerical values for the selected function.
Settings and values are selected, changed, set,
and accepted as indicated in the catalog of func-
tions and parameters.
If all the assignments of the key are to be de-
leted, select “SETTING” --> “CLR-SEL (4.8)”
in the catalog of functions and parameters then
press the MENU key. Answer the Safety inquiry
by pressing START.
Press ESC to exit deletion of SELECT
key assignments. The DATA and
MASTER keys have no effect here.
To Next Page
Loading...
Need help?
General
