Order No. Last Modification Version
3723047 November 08, 2016 Valid from program version V3.86 onward
Table of Contents
0 Initial commissioning ............................ 8
1 General points .......................................11
2 Control elements ..................................12
3 Performing basic settings .................. 19
3.1 Selecting the display language ...............19
3.2 Setting the contrast ......................................20
3.3 Setting the unit of measurement .........21
3.4 Setting the resolution/display format
of the measured value ................................ 22
3.5 Selecting the number of features/test
results to be displayed.................................23
4 Positioning the probe in the
measuring device (setup) .................. 25
5 Aligning probe sensitivity..................26
5.1 Calibrating a measuring channel .......... 27
5.2 Aligning the sensitivity of the probe
connected to C2 to that of the probe
connected to C1 .............................................28
6 Inputting settings for calculation
and display of a feature .....................29
6.1 Setting the factor for correcting
the indicated value of a feature ......29
6.2 Selecting a channel or channel
connection (formula) ....................................31
7 Selecting a feature ...............................32
8 Master measurement .......................34
8.1 How to select the type of master
measurement .................................................... 36
8.2 Entering the nominal master value for
a one-point master measurement ...... 36
8.3 Entering the nominal master value for
a two-point master mea sure ment ..... 37
8.4 Carrying out a one-point master
measurement .................................................... 39
8.5 Carrying out a two-point master
measurement .................................................... 39
9 Setting tolerances and limit values 40
9.1 Setting tolerance limits ............................... 40
9.2 Setting warning limits.................................. 42
9.3 Setting the color of the status lamps
for warning and tolerance limits .......... 44
9.4 Setting plausibility limits .............................45
To Next Page
Loading...
