Navigating the catalog of functions and parameters
Opening the catalog
The catalog of functions and parameters is
opened by pressing the MENU key while the
standard elements of the display are indicated. In
the top line of the numerical measured value dis-
play a text (e.g. "FEATR. 1" or "FEATURE") is
now output instead of a numerival value. In the
bottom line of the numerical display an ordinal
numer is displayed (e.g. "1.").
Significance of the elements
The text in the upper line of the numerical dis-
play indicates the currently selected function or
setting while the ordinal number below the text
indicates the position of the indicated function/
setting within the catalog of functions and pa-
rameters.
Key functions
When the catalog of functions and parameters
is open, only the keys DATA, MASTER, MENU,
ESC and START function .
The red arrows engraved on these keys indicate
the direction in which the operator will move
in the catalog of functions and parameters by
pressing the respective keys.
Navigating the catalog
Use the DATA and MASTER keys to display fur-
ther functions/settings located on the same level
of the catalog.
Press the MENU key to access the subfunctions/
settings of a function/subfunction that is cur-
rently displayed (i.e. you access the next lower
function level).
Press the ESC key to return to the next higher
function level.
Press START to accept parameter settings. This
automatically returns you to the next higher
function level.
The different function levels of the
catalog of functions and parameters
are indicated as columns in the fol-
lowing flow charts.
* The functions "FEATR. 2" and "FEATR. 1" (instead
of "FEATURE") will only be displayed if "2 FEAT.", was
selected under SETTING -> DISPLAY -> FEATURE.
The functions and settings offered for FEATURE,
FEAT. 1 and FEAT. 2 are identical.
** The "MASTER" function will only be displayed if the
setting "MAST 1P" was selected under PROCESS ->
MASTER.
*** The functions "MSTR.MAX" und "MSTR.MIN" will only
be displayed if the setting "MAST 2P" was selected un-
der PROCESS -> MASTER.
To Next Page
Loading...
Need help?
General
