Millimar C 1216 User Manual

88
Mahr GmbH, Millimar C1208/C1216/1240
Setting tolerances .........................................................40
Setting warning limits ...............................................42
Setup .....................................................................................25
Setup mode .....................................................................14
Shifting the probe’s characteristic curve ......35
Situation of the probe's characteristic curve .. 35
Specifying the measuring sequence .............48
START (Taste) ...................................................................17
Start a master measurement ...............................13
Start a time-controlled measurement ..........57
Start delay ..........................................................................51
Start measurement via control input ............. 57
Start measurement with START key ..............57
Status lamps .....................................................................17
Status lamp colors .......................................................44
Storage temperatures ..................................................2
Sum measurement .....................................................54
Symbols in the instructions ......................................1
System of protection .................................................80
T
T-PAUSE ............................................................................... 48
T-TIMER ................................................................................ 48
Technical data ................................................................. 80
Temperature coefficient ..........................................81
TEST .....................................................................................17
TIMER (3.1.2) ....................................................................48
TOLER. + (1.4.1.1; color setting) .........................44
TOLER. + (1.4.2; value setting) ...........................40
TOLER. - (1.4.1.2; color setting) ...........................44
TOLER. - (1.4.3; value setting) ..............................41
Tolerance, setting the ................................................40
Tolerance limited ...........................................................15
Tolerance limits ...............................................................40
TOLERNCE (1.4) .............................................................40
Transfer rate ...................................................................... 58
Transfer rate selection ...............................................62
Trends, identify ...............................................................15
Two-point master measurement ....................34
Type of master measurement ...........................36
U
U-OUTP. (4.7.3) ...............................................................75
UNIT (4.4) .......................................................................... 21
Unit of measurement ................................................21
Used devices .......................................................................2
Using the parallel (I/O) interface ......................70
Using the serial interface ........................................58
V
Value memories ............................................................56
Viruses ..................................................................................... 2
Voided warranty ..............................................................2
W
W.GREEN ............................................................................ 44
W.YELW ...............................................................................44
WARN. + (1.4.4; value) .............................................42
WARN. - (1.4.1.3; color setting) ........................... 44
WARN. - (1.4.5; value) ...............................................42
Warning limits .................................................................42
Warning limit monitoring ........................................43
Warranty ..............................................................................82
Weight ..................................................................................80
X
XON/XOF (data flow control mode) ............62
Z
Zero-modem cable .....................................................69

Millimar C 1216 Specifications

General

Brand	Millimar
Model	C 1216
Category	Measuring Instruments
Language	English