7. Press START. The selected feature display
mode flashes.
8. Press the START key again to adopt the
flashing mode. The display then returns to
the catalog of functions and parameters
item “FEATURE (4.1.1)”.
If at this point either the MASTER or DATA
key is pressed instead of START, the display
returns to the feature display mode selection
list (cf. point 7). The feature display mode can
be changed again.
9. If no further settings are to be made in the
catalog of functions and parameters, press
the START key. The standard display ele-
ments appear.
If further settings are necessary, navigate
to the appropriate point of the catalog of
functions and parameters using the ESC,
MASTER, DATA and MENU keys and carry
out the settings as required.
If the “2 FEAT.” or
“AUTODET” mode has been se-
lected, changes will have been
applied to the standard display
elements and/or the catalog of
functions and parameters.
AUTODET
If this mode has been selected,
the FEAT.2 function appears
in the catalog of functions
and parameters in addition to
FEAT. 1 or FEATURE. The
DET LIM function is also avail-
able under FEAT.1 (1) and
FEAT.2 (2). This function en-
ables limits to be set for auto-
matic feature detection.
2 FEAT.
If this mode has been selected,
the FEAT. 2 function ap-
pears in the catalog of functions
and parameters in addition to
FEAT. 1. The value of the sec-
ond feature is indicated in the
top line of the numerical display
instead of the current display
range and the value of the first
feature is displayed in the bot-
tom line.
To Next Page
Loading...
Need help?
General
