Millimar C 1216 - Page 68

66
Mahr GmbH, Millimar C1208/C1216/1240
Requesting the connection formula
PC :P50<CR>
Mil :P50,1+2<CR>, for connection formula
C1+C2
Specifying the connection formula
PC :P50,1-2<CR>
Mil :P50,1-2<CR>, sets connection formula
to C1-C2
i
Poss. connec-
tion formulae
Syntax
+C1 P50,1 <CR>
-C1 P50,-1 <CR>
+C2 P50,2 <CR>
-C2 P50,-2 <CR>
C1+C2 P50,1+2 <CR>
C1-C2 P50,1-2 <CR>
-C1+C2 P50,2-1 <CR>
-C1-C2 P50,-1-2 <CR>
i
When working with two features,
please observe that the connection
formula can only be changed for
FEAT. 1 !
Requesting the nominal size
PC :P91,Mn<CR>
Mil :P91,Mn,-xxx.xxx<CR>
Specifying the nominal size
PC :P91,Mn, xxx.xxx<CR>
Mil :P91,Mn,xxx.xxx<CR>
Requesting the master value
PC :P8,Mn<CR>
Mil :P8,Mn,-xxx.xxx<CR>
Specifying the master value
PC :P8,Mn, -xxx.xxx<CR>
Mil :P8,Mn,-xxx.xxx<CR>
Requesting the tolerance limits
PC :P21,Mn<CR>
Mil :P21,Mn,-xxx.xxx,xxx.xxx<CR>
Specifying the tolerance limits
PC :P21,Mn,-xxx.xxx,xxx.xxx<CR>
Mil :P21,Mn,-xxx.xxx,xxx.xxx<CR>
i
Here, the sequence of data seg-
ments is the following:
P21 --> Mn --> LTol --> UTol
Please not that the tolerance limits
are always entered with regard to
the nominal size!
Activating password protection
PC :P99,2<CR>
Mil :P99,2<CR>
Deactivating password protection
PC :P99,0<CR>
Mil :P99,0<CR>
i
The password (the seven digit
number) itself can only be entered
on the Millimar (refer to chapeter
11).
It is not possible to enter or change
the password via the PC.