Millimar C 1216 - Page 95

96 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

93

Mahr GmbH, Millimar C1208/C1216/C1240

Table of Contents

Default Chapter1
- Operating Instructions1
- Safety Instructions5
- Table of Contents7
Initial Commissioning10
1 General Points13
2 Control Elements14
3 Performing Basic Settings21
- Selecting the Display Language21
- Setting the Contrast22
- Setting the Unit of Measurement23
- Setting the Resolution/Display Format of the Measured Value24
- Selecting the Number of Features/Test Results to be Displayed25
4 Positioning the Probe in the Measuring Device (Setup)27
5 Aligning Probe Sensitivity28
- Calibrating a Measuring Channel29
- Aligning the Sensitivity of the Probe30
  - Connected to C130
6 Inputting Settings for Calculation and Display of a Feature31
- Setting the Factor for Correcting the Indicated Value of a Feature31
- Selecting a Channel or Channel Connection (Formula)33
7 Selecting a Feature34
8 Master Measurement36
- How to Select the Type of Master Measurement38
- Entering the Nominal Master Value for a One-Point Master Measurement38
- Entering the Nominal Master Value for a Two-Point Master Mea Sure Ment39
- Carrying out a One-Point Master41
- Measurement41
- Carrying out a Two-Point Master41
9 Setting Tolerances and Limit Values42
- Setting Tolerance Limits42
- Setting Warning Limits44
- Setting the Color of the Status Lamps for Warning and Tolerance Limits46
- Setting Plausibility Limits47
10 Setting Parameters for Recor Ding Measured Values48
- Setting Filter Parameters48
- Specifying the Measuring Sequence50
- Operating Mode "NORMAL52
- Operating Mode "AUTOM52
- Entering a Start Delay53
11 Password Protection54
12 Performing Measurements55
- Performing an Aggregate Measure56
  - Ment56
- Performing a Differential56
  - Measurement57
- Performing a Radial Run-Out Measure57
  - Ment57
13 Measured Value Memories58
14 Using the Serial Interface (RS 232)60
- Selecting the Interface Protocol60
- Selecting the Data Transfer Format62
- Selecting the Handshake63
- Selecting the Transfer Rate64
- Selecting How to Initiate Data Transfer65
- Examples of Interface Configuration66
- Connecting to a PC Using a Zero- Modem Cable (Circuit Diagram )71
15 Using the Parallel (I/O) Interface72
- Digital Control Output73
- Digital Control Input74
- Application Examples for the Use of Digital Control Inputs and Outputs76
- Analog Output77
  - (C 1216/C 1240 Only !!)77
  - Selecting the Feature to be77
    - Indicated77
    - The Analog Output79
16 Restoring the Factory Settings80
17 Error Messages81
18 Technical Data82
19 Mahr Contacts84
20 Warranty84
21 Index85
Navigating the Catalog of Functions and Parameters91

Related product manuals

Preview: Millimar C 1208

Millimar C 1208

Millimar C 1240