Milltronics ACCUMASS BW500 - Page 10

Page 10 Accumass BW500 PL-565
Specifications
Outputs:  mA:  1 programmable 0/4 - 20 mA, for rate, load and
speed output
 optically isolated
 0.1% of 20 mA resolution
 750 Ω load max
 see optional mA I/O board
 load cell:  10 V dc compensated excitation for strain gauge
type, 4 cells max, 150 mA max
 speed sensor:  12 V dc, 150 mA max excitation
 remote totalizer 1:  contact closure 10 - 300 ms duration
 open collector switch rated 30 V dc, 100 mA max
 remote totalizer 2:  contact closure 10 - 300 ms duration
 open collector switch rated 240 V ac/dc, 100 mA
max
 relay output:  5 alarm/control relays, 1 form 'A' SPST relay
contact per relay, rated 5 A at 250 V ac, non-
inductive
Communications:  two RS-232 ports
 one RS-485 port
 SmartLinx
®
compatible (see options)
Cable:  one load cell:
non-sensing:  Belden 8404, 4 wire shielded, 20 AWG or
equivalent, 150 m (500 ft) max
sensing:  Belden 9260, 6 wire shielded, 20 AWG or
equivalent, 300 m (1000 ft) max
 two / four* load cells:
non-sensing:  Belden 9260, 6 wire shielded, 20 AWG or
equivalent, 150 m (500 ft) max
sensing:  Belden 8418, 8 wire shielded, 20 AWG or
equivalent, 300 m (1000 ft) max
*for four load cell scale, run two separate cables of two load cell configuration
 speed sensor:  Belden 8770, 3 wire shielded, 18 AWG or
equivalent, 300 m (1000 ft)
 auto zero:  Belden 8760, 1 pair, twisted/shielded, 18 AWG,
300 m (1000 ft) max
 remote total  Belden 8760, 1 pair, twisted/shielded, 18 AWG,
300 m (1000 ft) max
Options:  Speed Sensor:  Mass Dynamics MD-36 / 36A / 256 or 2000A, or
RBSS, or compatible
 Dolphin Plus:  Milltronics Windows based software interface.
Refer to associated product documentation
 SmartLinx
®
Modules:  protocol specific modules for interface with
popular industrial communications systems.
Refer to associated product documentation.