Page 14 Accumass BW500 PL-565
Installation
Optional Plug-ins
SmartLinx
®
Module
The BW500 is software/hardware ready to accept the optional Milltronics SmartLinx
®
communications module that provides an interface to one of several popular
industrial communications systems.
Your BW500 may be shipped to you without a SmartLinx
®
module, for installation at a
later date.
If you are ready to install your SmartLinx
®
module, or want to change it, please follow
the instructions as outlined.
Installation
1. Isolate power and voltages applied to the BW500
2. Open the lid
3. Install the module by mating the connectors and secure in place using the two screws
provided.
4. Route communication cable to SmartLinx
®
module along the right side of the
enclosure wall. This route will reduce communication.
Note:
Refer to the SmartLinx
®
module documentation for any required hardware settings
prior to closing the lid.
5. Close the lid
6. Apply power and voltage to the BW500.
Refer to:
• SmartLinx
®
Module in the Specifications section on page 14,
• P750 – P769 SmartLinx
®
Module Specific Parameters on page 84 in this manual,
• the SmartLinx
®
manual for wiring.
To Next Page
Loading...