Milltronics ACCUMASS BW500 - Communications Parameters (P750-P792)

To Next Page

To Previous Page

Page 84 Accumass BW500 PL-565

Parameters

Communication (P750 - P792)

These parameters cover the various communications formats supported by the

BW500: serial printer, Dolphin Plus, SmartLinx

, and Modbus.

P750 – P769 SmartLinx

Module Specific Parameters

These parameters are specific to the SmartLinx

module installed. Refer to the

module documentation for a list and description of the specific parameter

requirements.

P770 – P789 Local Port Parameters

These parameters are specific to programming of the BW500 communication ports.

Refer to Communications for a listing and description of these parameters.

P790 SmartLinx

Error Status

Displays the results of ongoing hardware tests within the communications circuitry. If

any test does not meet the PASS requirements, communication halts and tests are

repeated until PASS requirements are met. Communication then resumes.

P791 SmartLinx

Protocol Status

P792 SmartLinx

Error Count

Displays the number or errors.

P799 Communications Control

Assigns programming control through the local keypad (or Dolphin Plus, P770 = 1),

or through a Modbus protocol (P770 = 2 or 3)

Entry:

0 = local

1 = modbus