PL-565 Accumass BW500 Page 111
Certification
Certification
For installations requiring trade certification, the BW500 provides a certification
compliance switch.
After certification of the installation has been obtained, the switch is set. The switch
must be positioned to the left to enable trade certification compliance.
When the switch is set for certification, editing of the parameter values, span
calibrations and totalizer resets are denied. Also, the maximum acceptable deviation
from one zero calibration to another is limited to an accumulated ± 2% of the initial
zero.
To set the certification switch, disconnect power before opening the enclosure lid.
• slide switch to the left position
• close the lid
• reconnect the power
Certification Printing
Certification printing is allowed if the following conditions are met:
• certification switch is set
• rate is below 2 %
• a communications port has been programmed for a printer
The printout must consist of the following:
Start Total: End total of previous print
End Total: Accumulated totalizer including Start Total
Net Total: End total minus Start Total
To Next Page
Loading...