50
Cut Out Data with Registration Mark
5
Set with the jog key or .
• Press the key. And the plotter
moves to the next scale compensation
setting.
• If [MARK DETECT] is set to [2ptA], the display for
inputting the B length will not appear.
• If [MARK DETECT] is set to [1pt], the scale compensation setting display will not appear
but the origin point will be displayed. (Step 7)
6
Press the key after
completing the settings.
• The registration mark detection will be
started.
• See "Setting the Number of Registration
Mark Detection" （ P. 44 ） for the
number of registration marks.
• In case the plotter cannot detect any
registration marks, it displays “Error 36 in
the registration mark detection” on the
display. Set the sheet again.
7
Set the origin.
• After the detection of the registration marks, the
display will show the available cutting area and
then return to local mode.
To Next Page
Loading...
