MIMAKI JV300-160 A - Chapter 2: Basic Operations; Power ON;OFF Procedures; Setting the Media; Test Printing

This chapter
describes procedures and setting methods for ink and media preparation, and printing.
Workflow .......................................................2-2
Turning the Power ON/OFF ..........................2-3
Turning the Power ON ................................ 2-3
Turning the Power OFF ............................... 2-3
Setting a Media .............................................2-4
Adjusting the Head Height .......................... 2-4
Setting a roll media ..................................... 2-5
Setting leaf media ....................................... 2-7
Changing the printing origin ........................ 2-8
Test Printing ..................................................2-9
Test Printing ................................................ 2-9
Perform test printing with the normal test
pattern ....................................................... 2-10
Perform test printing with the test pattern
for checking white ink ................................ 2-10
Head Cleaning ............................................2-11
About head cleaning ................................. 2-11
Perform head cleaning depending on the
test printing result ...................................... 2-11
Setting of Media Correction .........................2-11
Setting of Media Correction ......................2-11
If the Positions of Dots Shift... .....................2-12
Printing Data ...............................................2-12
Starting a Printing Operation .....................2-12
Stopping a Printing Operation ....................2-13
Deleting Received Data (Data Clear) ........2-13
Cutting a media ..........................................2-13
Chapter 2
Basic Operations