MIMAKI JV300-160 A - Stopping a Printing Operation; Deleting Received Data (Data Clear); Cutting a Media

2-13
2
2
2
5
6
Chapter 2 Basic Operation
Stopping a Printing Operation
Perform the following operation when stopping a printing
operation halfway.
1
Press the
(LOCAL)
during printing.
• The printing operation stops.
• Interrupt data sending at the PC side during the
data is sent from the PC.
• Printing restarts from the interrupted data by
repressing the [REMOTE] key.
Deleting Received Data (Data Clear)
When you want to stop printing, delete the already
received data.
1
Press the key, and press the
(DATA CLEAR)
in LOCAL.
2
Press the key.
• The received data is erased then it returns to the
Local.
Cutting a media
By using the keys on the operation panel, you can cut the
media at any position.
1
In Local, Press .
• It enters into the origin setting mode.
• By pressing [] , feed the media to the cutting
position.
2
Press the key.
• The media is cut.
• When the cutting has been completed, the current
mode returns to LOCAL.