MIMAKI JV300-160 A - Replace the CP Pad Set; Cleaning or Replace the Pinch Roller

Chapter 4 Maintenance
4-4
Replace the CP pad set
Replace CP pad set (SPA-0257) when it is dirty.
1
Push up the tabs (2places) of CP pad Assy.
2
Remove the CP pad Assy.
3
Attach a new CP pad Assy.
• After inserting the tabs of CP pad Assy to the slit
of C slider, fit the whole.
Cleaning or replace the pinch roller
Cleaning the pinch roller (SPA-0247) when it is dirty.
Also replace the pinch roller when it is worn or dirty.
1
Raise the clamp lever to keep the pinch
roller lifted.
2
Remove the O-ring retaining the pinch
roller.
3
Remove the pinch roller.
4
Clean the O-ring and pinch roller.
• Wipe off the ink sticking to the O-ring and pinci
roller with a clean stick dipped in cleaning solution
for maintenance. Wipe off so that cleaning
solution for maintenance will not remain.
• Attach a new pinch roller, and reattach a new O-
ring to their original position when dirt does not fall
even if it cleans it.
CP pad Assy
CP pad Assy
Tab s
C Slider
Press to lock the tab
• Be careful not to drop the parts in the gap of the
device as they are small.
• Be careful not to drop the parts in the gap of the
device as they are small.
O-ring
Pinch roller